DEEPBLU cosmiq+ - Entering the Water; Information During Your Dive

13
COSMIQ
+
Dive Computer
Back to Contents
check the current setting on your COSMIQ
+
at the top of the Scuba Mode screen after
the letter P.
5.2.2 Entering the water
There are two ways to start a dive in Scuba Mode: water activation and manual
activation.
Water activation: If Scuba Mode is your default dive mode, simply enter the water
when your COSMIQ
+
is in Standby or Watch Mode. Your COSMIQ
+
will automatically
activate Scuba Mode once you descend past 1.5 m (5 ft).. You can tell if the current
mode is the default mode when the letters dF show. This setting can be adjusted in
the Deepblu app.
NOTE: Because your COSMIQ
+
captures data at 15-second intervals in Watch Mode,
there may be a slight delay between descending below 2 m (6 ft) and Scuba Mode
activating. During a dive, however, the sample rate of your COSMIQ
+
is 1 second.
Manual activation: Manually navigate to Scuba Mode using the MODE button. Your
COSMIQ
+
will show you an overview of all your dive settings (see section 3 above).
Enter the water and begin your descent while in Scuba Mode.
NOTE: Make sure you reach depth within 3 minutes, before your COSMIQ
+
jumps
back into Watch Mode. When detecting pressure in Watch Mode, your COSMIQ
+
will
activate the default dive mode, which may or may not be Scuba Mode.
5.2.3 Information during your dive
Once your COSMIQ
+
starts logging your dive, it will disable the buttons for the
duration of your dive and display all necessary dive information at once on its bright
always-on display.
OVERVIEW
SAFETY
OPERATION
PAIRING
DIVING
DIVE LOGS
CARE
SPECS
WARRANTY
GLOSSARY
DIVING