DEEPBLU cosmiq+ - 5.2.9 Safety Stop; 5.2.10 Exceeding the No-decompression Limit

19
COSMIQ
+
Dive Computer
Back to Contents
Upon surfacing from a dive, or when you are shallower than 2 m (6 ft), your COSMIQ
+
will remain in Bottom Timer Mode for 5 minutes. If you surface for fewer than 5
minutes and then descend again, your COSMIQ
+
will consider this a continuation of
the previous dive and the calculations will continue from where they left off.
After 5 minutes, your COSMIQ
+
will begin to count the Surface Interval Time. It will be
displayed on the Watch Mode screen and counted upwards in hours and minutes.
Any additional descent will be considered a new dive.
The dive data recorded during each dive is accessible through Log Mode.
24-hour Scuba Mode lock
After completing a dive in BottomTimerMode,ScubaMode will be locked for the
next 24 hours.
Scuba Mode and the Dive Plan function will not be functional during this period and
will display the letters SUF. Scuba Mode will automatically switch to Bottom Timer
Mode when detecting pressure.
5.4 Diving in Freedive Mode
Freedive Modeisdesignedspecicallyforfreediving(apnea).Duringadive,your
COSMIQ
+
measures the current depth, dive time and water temperature. You can set
three depth alarms and one time alarm.
NOTE: Freediving after scuba diving severely increases your risk of decompression
illness. While Freedive Mode will be fully functional, your COSMIQ
+
will remind you of
the danger by displaying NO FrEE when you navigate to Freedive Mode after a dive
in Scuba Mode.
5.4.1 Setting time and depth alarms
You can set three depth alarms and one time alarm in Freedive Mode. These can be
set directly on the COSMIQ
+
or using the Deepblu mobile app.
To set depth and time alarms on your COSMIQ
+
, navigate to Freedive Mode using
the MODE button. Press the ADJUST button to access the alarm settings. Press
ADJUSTrepeatedlytosettherstdepthalarmatbetween10m(30ft)and80m(240
ft). Press MODE to set the second alarm and repeat until all three depth alarms are
set.
Next, press ADJUST repeatedly to set the desired time between 30 seconds and 10
minutes. Finally, press the MODE button to save your changes and return to Freedive
Mode.
OVERVIEW
SAFETY
OPERATION
PAIRING
DIVING
DIVE LOGS
CARE
SPECS
WARRANTY
GLOSSARY
DIVING