DEEPBLU cosmiq+ - Entering the Water; During Your Dive; After Your Dive

20
COSMIQ
+
Dive Computer
Back to Contents
TIP: Press and hold the ADJUST button to cycle through depth and time values
rapidly.
5.4.2 Entering the water
Just like diving in Scuba Mode, there are two ways to dive in Freedive Mode: water
activation or manual activation.
If your COSMIQ+ is set to use
Freedive Mode as the default dive mode, just
enter the water when in Standby or
Watch Mode and your COSMIQ+ will activate
Freedive Mode within seconds of detecting 1.5 m (4.5 ft) of water pressure. You can
tell if the current mode is the default mode when the letters
dF show. This setting
can be adjusted in the Deepblu app.
If it is not your default dive mode, simply navigate to Freedive Mode. Your COSMIQ
+
will stay in
Freedive Mode for 30 minutes. After 10 minutes, it will dim the screen
but remain in Freedive Mode for another 20 minutes, ready to activate upon
detection of pressure. After 30 minutes, your COSMIQ
+
will revert to Watch Mode.
5.4.3 During your dive
Once pressure is detected, COSMIQ
+
will lock into Freedive Mode. The MODE and
ADJUST buttons will be disabled for the duration of the dive. No settings can be
changed and no other modes can be accessed during the dive.
When you reach the depth(s) set on your depth alarm(s), the alarm will beep three
times. When you reach the dive time set on your time alarm, the alarm will sound for
6 cycles of 3 beeps per cycle.
A glance at your COSMIQ
+
will reveal the following information.
OVERVIEW
SAFETY
OPERATION
PAIRING
DIVING
DIVE LOGS
CARE
SPECS
WARRANTY
GLOSSARY
DIVING