Definitive Technology DYMENSION DM10 - Variable Bi-polar Bi-amping

30
Bi-amping | Variable bi-polar
Remove both jumper cables. Connect negative speaker wires from the negative am-
pliier binding post to the negative Rear and Speaker Input binding posts. Similarly,
Connect the positive speaker wire to the positive (red) rear (0db) and speaker input
binding posts. Connect a pair of interconnect cables between the first ampliier or
AVR pre-outs and the second ampliier or AVR amp-in inputs. Be sure to connect posi-
tive red binding posts to positive binding posts and negative to negative.
Note: To adjust the level of the rear array, use the volume controls on the second
ampliier or AVR. If that is not available, connect an attenuator between the irst and
second ampliier or AVR.
Speaker Out
Speaker Out
Audio Input
Amplifier 2
Amplifier 1
Preamp Out