Page 13
5. Maintenance and care
DANGER
Hot surfaces may cause burns!
Allow the appliance to cool down
before you clean it.
The surface may get damaged by
some detergents or cleaning materials.
Do not use aggressive detergents,
cleaning powder/cream or any sharp
objects. Do not use any harsh abrasive
cleaners or sharp metal scrapers to
clean the oven door and glass since
they can scratch the surface, destroy
the glass and could result in the glass
shattering.
HOOK
ELEMENT GUARD
ELEMENT
General information
x Clean the appliance thoroughly after each use,
making it easier to remove cooking residues and
helps prevent these from burning on the next use
of the appliance.
x Wipe down the cabinet, door, control panel, trims
and handles with a damp, hot soapy cloth.
x Use only liquid household cleaners and avoid
abrasive powders, scouring pads and caustic
cleaners.
x Rinse and wipe down with a clean cloth.
Cleaning the oven
x Open the oven door and allow the oven to cool
down.
x Clean the oven with a damp, hot soapy cloth. Do
not use a steam cleaner.
x It may be necessary to soak burnt soils with a
liquid cleaner to soften them before scrubbing
them with a nylon brush or scouring sponge.
x Heavy soils on the bottom of the oven may require
overnight soaking under a sponge liberally
sprinkled with household ammonia. Remove the
soil the following morning by washing normally.
x Always ensure that any excess liquid is thoroughly
wiped off after cleaning and any spillage is
immediately wiped dry.
x Do not use cleaning agents that contain acid or
chloride to clean the stainless or inox surfaces and
the handle. Use a soft cloth with a liquid detergent
(not abrasive) to wipe these parts clean, paying
attention to sweep in one direction.
x For your convenience, the shelves and the bake
element guard may be removed to improve
access. After cleaning fit the bake element guard
into the guard clips. (see diagram)
x Note: For both safety and performance
reasons the oven should not be operated
without the oven element guard in place.
Removing the oven door
Steps carried out during the removal
process should be carried out in
reverse order to install the door. Do not
forget to close the clips at the hinge
housing when reinstalling the door.
Lift-off oven door
The oven door may be removed to improve oven
access during cleaning.
Removing the oven door
1. Open the front door (1).
2. Open the clips at the hinge housing (2) on the right
and left hand sides of the front door by lifting them
up. Hold the door on both sides and then close the
door and lift the door up to remove it. Refitting is
the reversal of removing.
1 Front door
2 Hinge
3 Oven
Do not use steam cleaners for
cleaning, there is a risk of an electric
shock.
DANGER
Risk of electric shock!
Switch off the electricity before cleaning
the appliance to avoid an electric
shock.
To Next Page
Loading...
Need help?
General
