Page 14
DANGER: Before replacing the oven
lamp, ensure that the appliance is
disconnected from mains and cooled
down to avoid the risk of an electrical
shock. Hot surfaces may cause burns!
The oven lamp is a special electric light
bulb that can resist up to 300°C. See
Technical specifications for details. Oven
lamps can be obtained from Authorised
Service Agents.
Position of lamp might vary from the
figure.
Replacing the oven light bulb
To replace a faulty light bulb, proceed as follows:
1. Disconnect the product from mains.
2. Turn the glass cover counter clockwise to remove
it.
3. Remove the oven lamp by turning it counter
clockwise and replace it with the new one.
4. Install the glass cover.
Oven light
The oven light is switched on by the function
selector switch and switches off when the knob is
returned to 0.
6. Troubleshooting
Oven emits steam when it is in use.
It is normal that steam escapes during operation >>> This is not a fault.
The appliance emits metal noises while heating and cooling.
When the metal parts are heated, they may expand
and cause noise.
>>> This is not a fault.
The appliance does not operate.
The mains fuse is defective or has tripped.
Check fuses in the fuse box. If necessary, replace or
reset them.
The appliance is not plugged into the wall socket. >>> Check the plug connection.
Oven light does not work.
Oven lamp is defective. >>> Replace oven lamp.
Power is cut.
>>> Check if there is power. Check the fuses in the fuse
box. If necessary, replace or reset the fuses.
Oven does not heat.
Function and/or Temperature are not set.
>>> Set the function and the temperature with the
Function and/or Temperature knob/key.
If you have followed the instructions and still have a problem, contact the nearest Defy Technical
Support Centre. They will be able to advise you on any aspect of the product or send a qualified
technician to repair it. Never attempt to repair a defective appliance yourself.
Remember that you may be charged for a service call even during the warranty period if the fault is
due to or caused by any of the above.
Owner’s responsibility
Since the following are not factory faults, they are
the owner’s responsibility.
x Damage to exterior finish.
x Breakage of glass and other components.
x Replacement of the light bulb.
x Damage through improper use or installation of the
appliance.
x Damage caused by moving the appliance.
To Next Page
Loading...
Need help?
General
