Page 21 of 24
Maintenance and care
General cleaning information
General warnings
• Wait for the product to cool before cleaning
the product. Hot surfaces may cause
burns!
• Do not apply the detergents directly on the
hot surfaces. This may cause a permanent
stains.
• The appliance shall be thoroughly cleaned
and dried after each operation. Thus, food
residues shall be easily cleaned and these
residues shall be prevented from burning
when the appliance is used again later.
Thus, the service life of the appliance
extends and frequently faced problems are
decreased.
• Do not use steam cleaning products for
cleaning.
• Some detergents or cleaning agents may
damage the surface. Do not use abrasive
detergents, cleaning powders, cleaning
creams, descalers or sharp objects during
cleaning.
• There is no need for a special cleaning
agent for cleaning after each use. Clean
the appliance using dish soap, warm water
and a soft cloth or sponge and dry with a
dry microfiber cloth.
• Be sure to completely wipe off any
remaining liquid after cleaning and
immediately clean any food splashing
around during cooking.
• Do not wash any component of your
appliance in a dishwasher.
For the hob:
• Acidic dirt such as milk, tomato paste and
oil may cause permanent stains on the
cookers and components of the burners,
clean any overflown fluids immediately
after cooling down the cooker by turning it
off.
Inox and stainless surfaces
• Do not use acid or chlorine-containing
cleaning agents to clean stainless or inox
surfaces and handles.
• Stainless or inox surface may change
colour in time. This is normal. After each
operation, clean with a detergent suitable
for the stainless or inox surface.
• Clean with a soft soapy cloth and liquid
(non-scratching) detergent suitable for inox
surfaces, taking care to wipe in one
direction.
• Remove lime, oil, starch, milk and protein
stains on the inox-stainless and glass
surfaces immediately without waiting.
Stains may rust under long periods of time.
Glass surfaces
• When cleaning glass surfaces, do not use
hard metal scrapers and abrasive cleaning
materials. They can damage the glass
surface.
• Clean the appliance using dishwashing
detergent, warm water and a microfiber
cloth specific for glass surfaces and dry it
with a dry microfiber cloth.
• If there is residual detergent after cleaning,
wipe it with cold water and dry with a clean
and dry microfiber cloth. Residual
detergent residue may damage the glass
surface next time.
• Under no circumstances should the dried-
up residue on the glass surface be cleaned
off with serrated knives, wire wool or
similar scratching tools.
• You can remove the calcium stains (yellow
stains) on the glass surface with the
commercially available descaling agent,
with a descaling agent such as vinegar or
lemon juice.
• If the surface is heavily soiled, apply the
cleaning agent on the stain with a sponge
and wait a long time for it to work properly.
Then clean the glass surface with a wet
cloth.
• Discolorations and stains on the glass
surface are normal and not defects.
Plastic parts and painted surfaces
• Clean plastic parts and painted surfaces
using dishwashing detergent, warm water
and a soft cloth or sponge and dry them
with a dry cloth.
• Do not use hard metal scrapers and
abrasive cleaners. It may damage the
surfaces.
• Ensure that the joints of the components of
the appliance are not left as damp and with
detergent. Otherwise, corrosion may occur
on these joints.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
