SELF DIAGNOSTIC PROBLEM DISPLAY
• The machine has a self diagnostic capability and can therefore identify problem areas.
• In the event of a failure, a code will appear in the time indicator window.
• Please check the code against the following list and take the required action.
DISPLAY CAUSE ACTION REQUIRED
E1
BLOCKED WATER INLETOR
WATER FLOW IS IMPEDED
CHECK INLET HOSE FOR KINKS.
OPEN TAP MOREASK FOR REPAIR
E2
WATER HAS NOT DRAINED
COMPLETELY
CHECK DRAIN HOSE ASK FOR
REPAIR
E3
LID HAS NOT BEEN CLOSED
WHILE MACHINE IS ON SPIN
CYCLE
CLOSE LID
E4
OUT OF BALANCE LOAD RE-DISTRIBUTE CLOTHING EVENLY
AROUND THE TUB
LU
THE SUPPLY VOLTAGE IS
TOO LOW
MACHINE WILL OPERATE ONCE
VOLTAGE HAS STABILISED
E6
INSUFFICIENT PRE-SET
TIME
INCREASE PRE-SET TIME
F0
POWER SWITCH IS OUT OF
ORDER
REPAIR OR REPLACE SWITCH
F2
TROUBLE WITH E PROM ASK FOR REPAIR
F8
CLOTHING WEIGHT SENSOR
IS BROKEN
ASK FOR REPAIR
F9
WATER LEVEL SENSOR IS
BROKEN OR IT’S PLUG IS
LOOSE
ASK FOR REPAIR
To Next Page
Loading...
Need help?
General