AUTOMATIC PROGRAMMES
START
HOLD
PRESET
WATER
TEMP
AU TO
SPIN
TIME
RIN SE
WASH
TIME
WATER
LEVEL
POWER
Soak, Standard, Heavy, Fast and Wool programmes are stored in the machine’s
memory.
1 Press the POWER switch
The machine is ready to accept a programme selection.
2 Select the water temperature
Press the water temperature button to select a COLD, WARM or HOT wash.
Both indicator lights will glow when WARM is selected.
3 Press the AUTOMATIC button
Any of 5 automatic programmes may be selected according to material, and degree of
soiling.
SOAK, STANDARD, FAST, HEAVY or WOOL.
Press the button repeatedly until your choice is illuminated on the control panel.
4 Press the START / HOLD button.
The machine will start and complete the wash programme you have selected.
At the end of the wash cycle a buzzer will sound 6 times
NOTE
The automatic programmes may only be selected before the START / HOLD button is
pressed. If you wish to change the programme after the START / HOLD button has been
pressed, the power must be switched off and the sequence must be repeated afresh.
The SOAK programme takes about 32 to 44 minutes. Thereafter the
standard wash programme will commence.
To Next Page
Loading...
Need help?
General