INSTALLATION Continued
THE DRAIN HOSE
• Attach the drain hose to the drain outlet at the side of
the machine.
• Attach the looped end of the drain hose to an outlet
pipe, sink or suitable drain, the inlet of which should
be 1 metre or higher above floor level.
THE INLET HOSES
• Connect the inlet hoses to the machine inlet fittings. Left
for cold water and right for hot.
• Connect the respective inlet hoses to the hot and cold
water taps.
• Turn on the water taps and check for any leaks.
• Tighten fittings if necessary.
• Switch off the taps when the check is complete.
HOT WATER
• Do not use water hotter than 65 degrees Celsius.
• Very hot water could deform plastic parts of the
machine
ELECTRICAL CONNECTION
• The washing machine is designed to operate on a 230 Volt, 50 Hz, 15 Amp, AC power
supply.
• The machine should be connected to an earthed 3 pin wall socket.
• If the power-cord should ever need replacing, use only a genuine cord available from
the nearest Defy Service Centre.
The appliance must be earthed and the manufacturer and seller do not
accept responsibility for any damage due to incorrect electrical connection.
To Next Page
Loading...
