DelfiScan
Programming Manual
Configure Your DelfiScan
36
pre-defined auto power off time, the scanner enters the idle state after the pre-defined auto power off duration.
Presentation Scanning Mode
When the scanner is placed on SmartStand, the scanner’s built-in sensor will switch the scanner from ha
nd-held
scanni
ng to presentation scanning automatically. Three presentation scanning modes are available. Your are recommended to use flash mode or
force mode while under insufficient ambient light.
Only
Lower power mode
,
Trigger mode
,
Presentation mode
and
Level mode
are available for DelfiScan Laser model.
To Next Page
Loading...