DelfiScan
Programming Manual
Configure Your DelfiScan
4
Programming Procedures
As you scan the bar code command to select the desired parameters,
information about the final selected parameters represented by the
bar code commands are stored in the DelfiScan’s internal Flash
Memory ASIC or non-volatile memory. If you turn off the unit, the
Flash Memory ASIC or non-volatile memory retains all programming
options. You need not re-program the DelfiScan if you want to keep
the existing configurations in the next power on.
The programming procedures of DelfiScan are designed as simple as
possible for ease of setting. Most programming families take the
Single Scan Selection programming procedure. But several
programming families have more complex and flexible
programmable options, and you must take Multiple Scans
Selection, Cycling Scan Selection or Dual Level Selection to
complete their programming procedures. Each kind of programming
procedure is listed in the following pages for your reference. Please
give careful attention to become familiar with each programming
procedure.
If the programming family must take multi
ple scans selection, cycling
scan selection, or dual level selection procedures, the family of the
programming menu will be marked with the matched representing
symbol of Programming Category (P.C.) in bold font listed in the
following table. You can easily find the bold mark in the
programming menu, and refer to their flowcharts for details. Before
setting the DelfiScan, please also refer to the “Beeping Indications”
listed in Appendix to understand the details of programming
beeping indications. It will be very helpful for you to know the
existing status while you are programming the DelfiScan.
Conventions of Programming Menu
Conventions Descriptions
Factory Default Value
P.C. Programming Category
SS
: Signle scan selection
MS
: Multiple scans selection
CS
: Cycling scan selecti
on
DS
: Dual level scan selection
( ) Necessary Option Code
[ ] Selectable Option Code
To Next Page
Loading...