DelfiScan
Programming Manual
Configure Your DelfiScan
3
Bar Code Programming Menu
The DelfiScan bar code commands are specially designed Proprietary
bar code labels which allow you to set the DelfiScan internal
programming parameters. There are System Command, Family Code
and Option Code for programming purpose.
Each programmable family and bar code command label is listed on
the same page with major system commands. The detailed
explanations and special programming flowchart are printed on facing
or following pages. You can read the explanation and set the DelfiScan
concurrently.
A supplemental bar code command menu incorporates the bar code
command labels of System Command and Option Code. As you set the
DelfiScan, open the bar code command menu to find the option code
page. You may scan the desired family code and option code to set
DelfiScan. If you want to change the programming family for multiple
settings, you need only turn over the programming page to find next
desired programming family.
System Command
The System Command is the highest level bar code command which
directs DelfiScan to perform immediate operations, such as entering
programming mode (PROGRAM), exiting programming mode (EXIT),
listing system information (SYSLIST), recovering to factory preset
configurations (M_DEFAULT), and so on. Please note that all system
commands will take a few seconds to complete the operations. User
must wait for the completion beeps before scanning another bar code.
Family Code
The Family Code is scanned to select the user desired programming
family. DelfiScan has already provided more than one hundred
programming families to meet any specific requirements.
Option Code
The Option Codes is a set of bar code commands represented by
“0–9”, “ A–F” and finishing selection (FIN). For most setting, you
must select at least one option code following the family code
selection to set the desired parameter for the selected
programming family.
To Next Page
Loading...