Delfi DelfiScan C51 - Page 9

DelfiScan
Programming Manual
Configure Your DelfiScan
5
Scan
“END”
DelfiScan will exit programming mode, and store all
parameters in Flash Memory ASIC or non-volatile memory,
then issue the completion beeping.
Scan
“P
ROGRAM”
DelfiScan will enter programming mode,
and inhibit all non-programming functions.
Scan
“SYSLIST”
DelfiScan will list the product information and
revision number to host via selected host interface,
then issue the completion beeping.
Scan
“M_DEFAULT”
DelfiScan will recover all programmable
parameters into factory preset configurations,
then issue the completion beeping.
Program & End System List, Group & Master Default
Plea
se note that the DelfiScan will take 3-4 seconds to store
parameters in internal Flash Memory ASIC or non-volatile
memory after you scan the “END”. P l e a s e don’t turn off the
power before the completion beeping. It may destroy all
configured parameters.