Part Number: 9291458 REV00 12/19 27
Section 2 Installation
NOTE: CONT: the condensing unit’s finned coil.
Any restriction to the proper air flow will void the
compressor warranty.
• Louver measures 20.00” x 25.00” (51cm x 64cm).
• Louver Cutout Size is 18.50” x 22.50” (47cm x 57cm)
(typical installation).
Finned Coil
Duct
Partitions Not Shown
Louver
Suggested Drainage Trap
Units may increase in performance if they have a
drainage trap or shut-off valve installed. Installing the
trap will stop warm air being introduced into the dry
well of the unit.
To Next Page
Loading...
