Installing the speaker board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speaker board and provides a visual representation of the installation
procedure.
Steps
1. Align and place the speaker board into its slot in the computer.
2. Replace the two (M2x2.5) screws to secure the speaker board to the computer.
3. Connect the speaker board FPC cable to the system board and speaker cable to the speaker board.
4. Connect the fan cable to the system board.
Next steps
1. Install the base cover.
2. Install the microSD card.
3.
NOTE: Plug-in AC before powering up your computer.
Follow the procedure in after working inside your computer.
Removing and installing components
33
To Next Page
Loading...
