I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Enter the service mode.
3. Remove the microSD card.
4. Remove the SIM card.
5. Remove the base cover.
6. Remove the solid-state drive.
7. Remove the heatsink assembly.
8. Remove the system board.
About this task
The following images indicate the location of the I/O board and provide a visual representation of the removal procedure.
Steps
1. Remove the single (M2x2.5) screw and two (M2x4) screws securing the I/O board to the computer.
2. Lift and remove the I/O board from the computer.
Installing the I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
63
To Next Page
Loading...
