4. Route the display cable along the guiding tabs on the tweeters and connect the display, camera, touch screen and, sensor
board cables to the system board.
NOTE: For models shipped with a WLAN antenna in the display assembly, route the tweeter speaker cable along the top
side of the palmrest assembly and secure it in place with tape.
5. Replace the display cable bracket on the eDP connector on the system board.
6. Replace the two (M2x2) securing the display cable bracket to the system board.
Next steps
1. Install the heatsink assembly.
2. Install the base cover.
3. Install the microSD card.
4.
NOTE: Plug-in AC before powering up your computer.
Follow the procedure in after working inside your computer.
Tweeters and palmrest antenna assembly
Removing the tweeters and palmrest antenna assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD card.
3. Enter the service mode.
4. Remove the base cover.
5. Remove the heatsink assembly.
About this task
The following images indicate the location of the tweeters and palmrest antenna assembly and provide a visual representation of
the removal procedure.
50
Removing and installing components
To Next Page
Loading...
