Steps
1. Remove the two (M2x2) screws securing the display cable bracket to the system board and disconnect the display cable.
2. Disconnect the camera, touch screen, sensor board cables from the system board and unroute them from the guiding tabs
on the tweeters.
3. Disconnect the tweeter cable from the audio board and peel back the mylar tape securing the tweeter cable to the keyboard
bracket, audio board FFC and, I/O board.
4. Pry and remove the tweeters from the computer.
Installing the tweeters
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the tweeters and provides a visual representation of the installation procedure.
48
Removing and installing components
To Next Page
Loading...
