Dell EMC Latitude 7520 - Power button with fingerprint reader installation

Steps
1. Replace the power button with fingerprint reader into its slot in the computer.
2. Secure the power button with fingerprint reader to the computer using the two (M1.6x1.7) screws.
Next steps
1. Install the system board.
2. Install the heatsink assembly.
3. Install the solid-state drive.
4. Install the base cover.
5. Install the SIM card.
6. Install the microSD card.
7.
NOTE: Plug-in AC before powering up your computer.
Follow the procedure in after working inside your computer.
Keyboard
Removing the keyboard
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD card.
3. Remove the base cover.
4. Remove the solid-state drive.
5. Remove the WWAN card.
6. Remove the battery.
7. Remove the heatsink assembly.
8. Remove the speaker board.
66
Removing and installing components