Steps
1. Align and place the display assembly at a convenient angle to the bottom chassis.
2. Replace the six (M2.5x5) screws securing the hinges to the bottom chassis.
3. Route the display cable along the guiding tabs and connect the display, camera, touch screen, sensor board cables to the
system board.
4. Align and place the display cable bracket on the connector on the system board.
5. Install the two (M2x2) screws securing the display cable bracket to the system board.
Next steps
1. Install the base cover.
2. Install the microSD card.
3.
NOTE: Plug-in AC before powering up your computer.
Follow the procedure in after working inside your computer.
Installing the display assembly (with WLAN antenna)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
42
Removing and installing components
To Next Page
Loading...
