Steps
1. Adhere the tape securing the tweeter cable to the audio board FFC and I/O board.
2. Adhere the mylar tape securing the tweeter cable to the keyboard bracket and connect the tweeter cable to the audio
board..
3. Route the display cable along the guiding tabs on the tweeters.
NOTE:
When routing the tweeter cable, secure the speaker cable in place with the cut outs on the keyboard plate and
mylar tape attached to the speaker cable.
4. Replace the tweeters and palmrest antenna assembly into its slot in the palmrest assembly.
5. Connect the display, camera, touch screen, sensor board cables to the system board.
6. Replace the display cable bracket on the eDP connector on the system board.
7. Replace the two (M2x2) securing the display cable bracket to the system board.
8. Connect the antenna cable to the WLAN module on the system board.
9. Replace the WLAN antenna bracket and the single (M2x2) screw securing the bracket to the WLAN module on the system
board.
Next steps
1. Install the heatsink assembly.
2. Install the base cover.
3. Install the microSD card.
4.
NOTE: Plug-in AC before powering up your computer.
Follow the procedure in after working inside your computer.
Removing and installing components
53
To Next Page
Loading...
