CAUTION: Do not power up the switch if you did not install a fan module.
NOTE: A US AC power cable is included for powering up an AC power supply. You
must order all other power cables separately.
NOTE: ESD damage can occur if components are mishandled. Always wear an ESD-
preventive wrist or heel ground strap when handling the switch and its components.
Power up sequence
When the switch powers up, the fans immediately come on at high speed. The fan speed
slows as the switch continues to boot up.
After switch installation
After you have securely installed and powered on the Z9264F-ON switch:
• If you are using Dell EMC software, see switch documentation at www.dell.com/
support.
• If you need ONIE information, see ONIE documentation at www.onie.org.
• If you are using third-party software, see your third-party documentation.
16 Z9264F-ON switch installation
To Next Page
Loading...
