CAUTION: On the AC switch, use the power supply cable as the main disconnect
device. Ensure that the socket-outlet is located/installed near the equipment and is
easily accessible.
NOTE: Module power is software controlled. You do not see module LEDs when the
switch powers up in ONIE.
Storing components
If you do not install your Z9264F-ON switch and components immediately, properly store
the switch and all optional components following these guidelines:
• Storage location temperature must remain constant. The storage range is from -40° to
70°C (-40° to 158°F).
• Store on a dry surface or oor, away from direct sunlight, heat, and air conditioning
ducts.
• Store in a dust-free environment.
NOTE: ESD damage can occur when components are mishandled. Always wear an
ESD-preventive wrist or heel ground strap when handling the switch and its
accessories. After you remove the original packaging, place the Z9264F-ON switch
and its components on an anti-static surface.
Site preparations 9
To Next Page
Loading...
Need help?
General