To Next PageTo Next Page
Need help?Do you have a question about the Dell 1920W and is the answer not in the manual?
General| Device Type | UPS |
|---|---|
| Rack Size | 2U |
| Frequency | 50/60 Hz |
| Communication Interface | USB, Serial |
| Input Voltage | 100 - 240 V AC |
| Output Voltage | 100 - 240 V AC |
| Battery Type | Sealed Lead Acid |
| Typical Recharge Time | 3 hours |
| Operating Temperature | 0 - 40 °C |
| Storage Temperature | -15 - 45 °C |
| Humidity | 0 - 95% |
Explains the meaning of NOTE, CAUTION, WARNING, and DANGER indicators.
Warning about lethal voltages and the prohibition of user-serviceable parts.
Describes the initial steps for setting up the UPS system.
Guides on how to proceed with setting up the UPS based on installation type.
Details how to open the battery cover for rackmount installation.
Instructions for reconnecting the internal battery connector and tray.
Steps to remove brackets for tower installation of the 2700W UPS.
Instructions for connecting the internal battery connector during tower setup.
Steps to install the front cover after rotating the control panel.
Instructions for connecting the UPS to a computer via USB or RS-232.
Guidance on connecting the ground cable to the UPS.
Information on installing the Remote Emergency Power-off (REPO) switch.
Steps to plug equipment into UPS outlets, with an overload warning.
Verifying normal operation and checking for alarms after startup.
