Dell 5000 Series - 15 Replacing the Base Frame; Procedure; Post-Requisites

15
Replacing the base frame
WARNING: Before working inside your computer, read the safety information that shipped with
your computer and follow the steps in Before working inside your computer. After working inside
your computer, follow the instructions in
After working inside your computer. For more safety
best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1. Place the base frame on the bottom cover.
2. Connect the Dip Switch board cable and status-light board cable from the system board
3. Connect the wireless card cables and mobile broadband card cables from the routing guides.
4. Replace the system grounding port screw.
5. Turn the system over.
6. Replace the screws that secures the bottom cover to the base frame.
7. Turn the system right side up.
Post-requisites
1. Replace the mobile broadband card.
2. Replace the wireless card.
3. Replace the solid-state drive.
4. Replace the top cover.
27