Dell 5000 Series - 16 Removing the DIP Switch Board; Prerequisites; Procedure

16
Removing the DIP switch board
WARNING: Before working inside your computer, read the safety information that shipped with
your computer and follow the steps in Before working inside your computer. After working inside
your computer, follow the instructions in
After working inside your computer. For more safety
best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1. Remove the top cover.
2. Remove the solid-state drive.
3. Remove the wireless card.
4. Remove the mobile broadband card.
5. Remove the base frame.
Procedure
1. Remove the screws that secure the DIP switch board assembly to the status-light board.
2. Lift the DIP switch board assembly of the status-light board.
28