2. Remove the left-side cover.
3. Remove the top cover.
4. Remove the right-side cover.
5. Remove the front bezel.
6. Remove the memory modules.
7. Remove the single-graphics card.
8. Remove the 2230 solid-state drive or the 2280 solid-state drive in SSD slot one, as applicable.
9. Remove the 2230 solid-state drive or the 2280 solid-state drive in SSD slot two, as applicable.
10. Remove the wireless card.
11. Remove the processor liquid-cooling assembly or processor fan and heat-sink assembly, as applicable.
12. Remove the processor.
13. Remove the VR heat sink.
About this task
The following image indicates the connectors on your system board.
88 Removing and installing components
To Next Page
Loading...
