Table 33. System setup options—Integrated Devices menu(continued)
Integrated Devices
By default, the Enable External USB Ports option is enabled.
Enable Thunderbolt Boot Support
Enable Thunderbolt Boot Support Enables the Thunderbolt adapter-peripheral device and USB devices that are
connected to the Thunderbolt adapter to be used during BIOS Preboot.
By default, the Enable Thunderbolt Boot Support option is disabled.
Enable Thunderbolt (and PCIe behind TBT)
pre-boot modules
Enables the PCIe devices that are connected through a Thunderbolt adapter to run
the PCIe devices UEFI Option ROM (if present) during preboot.
By default, the Enable Thunderbolt (and PCIe behind TBT) pre-boot modules
option is disabled.
Table 34. System setup options—Storage menu
Storage
SATA/NVMe Operation
SATA/NVMe Operation Sets the operating mode of the integrated SATA hard drive controller.
By default, the AHCI/NVMe option is selected. The storage device is configured
for AHCI/NVMe mode.
Storage Interface Displays the information of various onboard drives.
Port Enablement Enables or disables the M.2 PCIe SSD option.
By default, the M.2 PCIe SSD option is enabled.
SMART Reporting
Enable SMART Reporting When enabled, the BIOS can receive analytical information from integrated drives
and send notifications during startup about possible future failure of the hard drive.
By default, the Enable SMART Reporting option is disabled.
Drive Information Displays the information of onboard drives.
Enable MediaCard
Secure Digital (SD) Card Enables or disables the SD card.
By default, the Secure Digital (SD) Card option is enabled.
Secure Digital (SD) Card Read-Only Mode Enables or disables the SD card read-only mode.
Table 35. System setup options—Display menu
Display
Display Brightness
Brightness on battery power Enables to set the screen brightness when the computer is running on battery power.
By default, the screen brightness is set to 50 when the computer is running on
battery power.
Brightness on AC power Enables to set the screen brightness when the computer is running on AC power.
By default, the screen brightness is set to 100 when the computer is running on AC
power.
Full Screen Logo Enables or disables the computer to display a full-screen logo, if the image matches
screen resolution.
By default, the Full Screen Logo option is disabled.
113
To Next Page
Loading...
