# support notification enable all
Enabled sending autosupport and alerts to EMC.
4. To set the notification method to ConnectEMC, enter:
# support notification method set connectemc
Support notification method set to "connectemc".
5. To show the notification setup, enter:
# support notification show all
Notification Status Destination
------------ ------- -----------------------
alerts enabled ftp://111.111.11.111:11
autosupport enabled ftp://111.111.11.111:11
------------ ------- -----------------------
6. To show the notification setup, enter:
# support connectemc config show
ConnectEMC configuration:
ESRS gateway IP/hostname: esrs-gateway.datadomain.com
Registered device IP(s) 10.25.246.70
7. To test the configuration after enablement, enter:
# support connectemc test
Sending a test event...
Configure System for Use 39
To Next Page
Loading...
