Removing and Installing Parts 67
Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
1
Follow the procedures in "Before You Begin" on page 45.
2
Release and remove the front panel (see page 60).
NOTE: If you are adding a floppy drive, see "Installing a Floppy Drive" on page 68.
Removing a Floppy Drive
1
Disconnect the power and data cables from the back of the floppy drive and from the system board
(see page 53).
2
Remove the floppy drive bracket from the computer:
a
Remove the bracket-securing screw for the floppy drive.
b
Remove the bracket for the floppy drive from the computer.
power cable
data cable
To Next Page
Loading...
