96 Adding Parts
www.dell.com | support.dell.com
Card Installation
1 To add or replace the card, gently press it down into the slot connector
until it clicks into place.
2 Release the card clip lever, ensuring that the tab on the card clip lever
fits into the notch on the front end of the card.
3 Secure the card by lowering the hinged lever on the back panel.
4 If you disconnected a power cable from the card in step 1 of the
previous procedure, reconnect the cable to the card.
5 Close the computer cover (see page 104).
NOTICE: To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
6
Connect your computer and devices to electrical outlets, and turn
them on.
card clip
lever
AGP card
card clip
slot connector
To Next Page
Loading...
