Replacing the base frame
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Place the base frame on the bottom cover.
2 Connect the Dip Switch board cable and status-light board cable from
the system board
3 Connect the wireless card cables and mobile broadband card cables
from the routing guides.
4 Replace the system grounding port screw.
5 Turn the system over.
6 Replace the screws that secures the bottom cover to the base frame.
7 Turn the system right side up.
Post-requisites
1 Replace the mobile broadband card.
2 Replace the wireless card.
3 Replace the solid-state drive.
4 Replace the top cover.
33
To Next Page
Loading...
