Dell EMC PowerEdge T440 - Drive Specifications; Drives; Optical Drive; Ports and Connectors Specifications

Drive specications
Drives
The PowerEdge T440 system supports:
• Up to 4 x 3.5 inch cabled drives with drive adapter, internal, SATA, or Nearline SAS drives
or
• Up to 8 x 3.5 inch hot swappable drives with drive adapter, internal, hot swappable SAS/SATA drives
or
• Up to 16 x 2.5 inch hot swappable drives with drive adapter, internal, hot swappable SAS/SATA drives
Optical drive
The T440 system supports one optional slim SATA DVD-ROM drive or DVD +/-RW drive.
Ports and connectors specications
USB ports
The table provides information about the supported USB port specications.
Table 17. USB
specications
System Front panel Back panel
PowerEdge T440
• One USB 2.0-compliant port
• One USB 3.0-compliant port
• Four USB 2.0-compliant rear ports
• Two USB 3.0-compliant rear ports
NIC ports
The PowerEdge T440 system supports two Network Interface Controller (NIC) ports on the back panel each with 1 Gbps conguration.
NOTE
: You can install up to six PCIe add-on NIC cards.
VGA ports
The Video Graphic Array (VGA) port enables you to connect the system to a VGA display. The T440 system supports one 15-pin VGA ports
on the back of the system.
Serial connector
The T440 system supports one serial connector on the back panel, which is a 9-pin connector, Data Terminal Equipment (DTE), 16550-
compliant.
Dell EMC PowerEdge T440 Installation and Service Manual
Technical specications
35