Dell EMC VxFlex Series - Install the Strain Relief Bar, Route and Secure Cables; Installing the Front Bezel on the System

Figure 44 Installing the front bezel on the system
Install the strain relief bar, route and secure cables
Install the strain relief bar (SRB) on the rack, and the hook-and-loop straps that secure cable bundles.
About this task
Install the SRB attachment brackets at the back of the sliding rail with corresponding SIDE A and SIDE B marking.
The SRB has two depth positions. Use depth position 1 for deep racks, and depth position 2 for shallow racks.
Procedure
1. Align the holes on the SRB brackets with the pins on the slide rail, and push the brackets downward until they
lock into place.
2. Insert the ends of the SRB into the SRB brackets until it locks into place.
R840 Equipment Installation
Dell EMC VxFlex Ready Node Server Installation Guide 87