Dell Force10 C150 - Installing a DC PEM; DC PEM Cable and Connector Requirements

28 Installing the Software
Assign an IP address to a VLAN
NOTE: An IP address cannot be assigned to the Default VLAN, which, by default,
is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default
vlan-id vlan-id command.
Connecting the Chassis to the Network
Once you have completed the hardware installation and software configuration,
you can connect to your company network by following your company’s cabling
requirements.
Step Task Command Syntax Command Mode
1 Assign a switchport to a
VLAN.
[tagged | untagged] interface INTERFACE VLAN
2 Display all switchports
and the VLANs of which
they are members.
show vlan EXEC Privilege
Task Command Syntax Command Mode
Configure an IP address and mask on
the interface.
ip address ip-address
mask [secondary]
INTERFACE