Virtual Server Networking | 49
After you enable VSN on an interface and enable a hypervisor session that connects
to hypervisors on network servers, you can change the
mode setting when the session
is active. You cannot, however, change the
type and access settings if the session is
active. To change these settings, you must:
1. In hypervisor configuration mode, stop the session by entering the
disable
command.
2. Enter the
no type {vmware | xen-citrix} or no access url username username
password password
command to remove a configured setting.
3. Enter the
type {vmware | xen-citrix} or access url username username password
password
command to configure a new setting.
4
Establish the connection between the
switch and a hypervisor
access url username username
password password
Where url is one of the following values:
For a VMware hypervisor:
https://[ip-address]/sdk/vimService
username [name] password [password]
For an Xen hypervisor:
http://ip-address username [name]
password [password]
username name: Username to be used for
authentication on the server.
password password: Password to be used for
authentication shown in clear text.
HYPERVISOR
5
Set the mode for retrieving virtual
server configurations and updating
FTOS settings on the switch.
mode {check | config}
check: Retrieve configuration information
from the hypervisor, and notify the system
administrator of any configuration
changes. The configuration changes need
to be entered manually on the switch.
config: Retrieve configuration information
and automatically update the configuration
parameters in FTOS on the switch.
Default: config.
HYPERVISOR
6
Enable the defined hypervisor
connection.
no disable HYPERVISOR
Step Task Command Syntax Command Mode
To Next Page
Loading...
Need help?
General
