Dell FORCE10 Open Automation User Manual

About this Guide | 5
1
About this Guide
Objectives
This document describes the components and uses of the Open Automation
Framework designed to run on the Force10 Operating System (FTOS), including:
• Smart Scripting
• Virtual Server Networking (VSN)
• Programmatic Management
• Web graphic user interface (GUI) and HTTP Server
Information another feature, Bare Metal Provisioning (BMP) that interacts with the
Open Automation Framework can be found in the
FTOS Configuration Guide.
Audience
This document is intended for data center managers and network administrators
responsible for virtualization or system management. It assumes basic knowledge
about virtualization technology and networking.
Supported Platforms and Required FTOS
Versions
The Open Automation 2.0 release is supported on the following Dell Force10
switches and minimum FTOS versions:
• S55 switches require FTOS version 8.3.5.2 or later.
• S60 switches require FTOS version of 8.3.3.7 or later.
Note: Although this document contains information on protocols, it is not intended to provide complete
information on protocol configuration and usage. For this information, refer to the document listed in
Related Documents on page 7 and the IETF Requests for Comment (RFCs).

Dell FORCE10 Open Automation Specifications

General

Series	FORCE10
Model	Open Automation
Jumbo Frame Support	Yes
Product Type	Switch
Ports	Varies by model
Switching Capacity	Varies by model
Forwarding Rate	Varies by model
MAC Address Table Size	Varies by model
Power Supply	Varies by configuration
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Dimensions	Varies by model
Weight	Varies by model