Installing the Hardware 15
Install a DC Power Supply
The power supply modules should slide into the slots smoothly. Do not force a
module into a slot. This may damage the power supply or the chassis.
S55 S60
Step Task
1
Take the power supply unit out of the shipping box.
2
Remove the small plastic cover over the DC connectors. Do not
throw the cover away; you will replace it when installation is
complete.
3 Using the grab handle, slide the unit in to the power supply bay.
4 Tighten the securing screw at the top of the unit.
5 Attach power cables.
6 Replace the small plastic cover over the DC connectors.
7 Turn on power if installing a DC unit.
To Next Page
Loading...
