Installing the Software 19
USB-B Console
The USB-B connector port is labeled on the S55/S60 chassis. It is to the left of
the management ports, as you face the rear of the chassis.
NC 2 7 6 DSR
TxD362RxD
GND 4 5 5 GND
GND 5 4 5 GND
RxD633TxD
NC 7 2 4 DTR
CTS817RTS
S55
S60
Step Task
1 Power on the PC (XP operating system recommended).
2 Connect the USB-A end of cable (supplied) into an available USB port on the
PC.
3 Connect the USB-B end of cable into the USB-B console port on the chassis.
4 Power on the chassis.
5 Install necessary USB device drivers (internet connection required).
Contact Dell Force10 TAC for CD, if necessary.
Table 2-1. Pin Assignments Between the Console and a DTE Terminal Server
S55/S60
Console Port
RJ-45 to RJ-45 Rollover Cable RJ-45 to DB-9
Adapter
Terminal
Server Device
Signal RJ-45 pinout RJ-45 Pinout DB-9 Pin Signal
To Next Page
Loading...
