Need help?Do you have a question about the Dell Force10 S4820T System and is the answer not in the manual?
General| Switching Capacity | 1.28 Tbps |
|---|---|
| Forwarding Rate | 952 Mpps |
| Power Supply | Dual, hot-swappable |
| Rack Units | 1U |
| Airflow | Front-to-back or back-to-front |
| Manageable | Yes |
| Form Factor | Rack-mountable |
| RAM | 4 GB |
| MAC Address Table Size | 128, 000 entries |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Uplink Ports | 4 x 40GbE QSFP+ |
| Jumbo Frames | 9216 bytes |
| Dimensions (H x W x D) | 4.32 cm x 44.3 cm x 50.8 cm |
| Storage Temperature | -40°C to 70°C |
| Latency | 650 ns |
| Weight | 22.05 lbs (10 kg) |
| Relative Humidity | 10% to 85% (non-condensing) |
Details package contents and provides step-by-step instructions for unpacking the switch.
Step-by-step instructions for unpacking the switch and inspecting it for damage.
Key safety guidelines and considerations for properly mounting the switch in a rack.
Guidance on configuring and attaching switch rails for a 1U front-rack setup.
Details the physical dimensions of the S4820T chassis, including height, width, and depth.
Lists the operating and storage environmental parameters like temperature and humidity.
Specifications for AC power supply, including current draw and maximum consumption.
Details the DC input voltage range and related power specifications.
Explains how to navigate through the different Command Line Interface (CLI) modes for configuration.
Details how to establish console access to the S4820T system using a terminal emulation program.
Steps to configure interfaces for Layer 2 data transmissions and switching.
Procedure for setting a custom host name for the S4820T system.
Steps to assign an IP address to the management port for remote access.
How to assign interfaces to a VLAN using tagged and untagged commands.
To Next Page