Installing the Software 19
Assign an IP Address to a VLAN
NOTE: An IP address cannot be assigned to the Default VLAN, which, by default,
is VLAN 1. To assign another VLAN ID to the Default VLAN, use the default
vlan-id vlan-id command.
Connecting the Z9000 to the Network
Once you have completed the hardware installation and software configuration,
you can connect to your company network by following your company’s cabling
requirements.
Step Task Command Syntax Command Mode
1 Access the
INTERFACE VLAN
mode of the VLAN to
which you want to
assign the interface.
interface vlan vlan-id CONFIGURATION
2 Configure an interface
as untagged. This
command is available
only in VLAN
interfaces.
untagged interface INTERFACE
Task Command Syntax Command Mode
Configure an IP address
and mask on the interface.
ip address ip-address mask
[secondary]
INTERFACE
To Next Page
Loading...
