2. Follow the procedure in After working inside your computer.
Removing the M.2 2280 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
NOTE: This procedure applies only to computers shipped with an M.2 2280 solid-state drive installed.
NOTE: The M.2 card installed will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
● M.2 2230 solid-state drive
● M.2 2280 solid-state drive
The following image(s) indicate the location of the M.2 2280 solid-state drive and provide a visual representation of the removal
procedure.
Steps
1. Remove the screw (M2x3) that secures the solid-state drive thermal shield to the palm-rest and keyboard assembly.
2. Slide and lift the thermal shield away off the M.2 2280 solid-state drive.
3. Slide and lift the M.2 2280 solid-state drive from the M.2 card slot on the system board.
Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: This procedure applies if you are installing a M.2 2280 solid state drive.
Removing and installing components 17
To Next Page
Loading...
