Steps
1. Connect the touchpad cable to the touchpad and close the latch.
2. Align and place the touchpad along with its cable on the palm-rest and keyboard assembly.
3. Replace the two (M2x2) screws that secure the touchpad to the palm-rest and keyboard assembly.
4. Align and place the touchpad bracket on the palm-rest and keyboard assembly.
5. Replace the four (M2x2) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
6. Connect the touchpad cable to the system board and close the latch.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in Before working inside your computer.
Removing and installing components
31
To Next Page
Loading...
