Steps
1. Place the I/O board cable on the palm-rest and keyboard assembly.
2. Connect the I/O board cable to its connector on the I/O board and close the latch.
3. Connect the I/O board cable from its connector on the system board and close the latch.
Next steps
1. Install the heat sink.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Power button
Removing the power button
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the display assembly.
4. Remove the I/O board.
About this task
The following image(s) indicate the location of the power button and provide a visual representation of the removal procedure.
Steps
1. Remove the screw (M2x2) that secures the power button to the palm-rest and keyboard assembly.
2. Lift the power button off the palm-rest and keyboard assembly.
Removing and installing components
35
To Next Page
Loading...
