Steps
1. Place the heat sink on the system board.
2. Align the screw holes of the heat sink to the screw holes on the system board.
3. In sequential order (1>2>3>4>5>6>7>8>9), replace the nine (M2x3) screws that secure the heat sink to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
Removing and installing components
27
To Next Page
Loading...
