2. Remove the base cover.
About this task
The following image(s) indicate the location of the I/O board and provide a visual representation of the removal procedure.
Steps
1. Remove the two (M2.5x5) screws that secure the left-display hinge to the system board.
2. Open the left-display hinge at an angle of 90 degrees.
3. Lift the latch and disconnect the I/O board cable from its connector on the I/O board.
4. Remove the two (M2x3) screws that secure the I/O board in place.
5. Lift the I/O board off the palm-rest and keyboard assembly.
Installing the I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the I/O board and provide a visual representation of the installation procedure.
32
Removing and installing components
To Next Page
Loading...
