Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the palm-rest and keyboard assembly and provide a visual representation of the
installation procedure.
Steps
Place the palm-rest and keyboard assembly on a flat and clean surface and perform the post-requisites to install the palm-rest
and keyboard assembly.
Next steps
1. Install the system board.
2. Install the power button.
3. Install the I/O board cable.
4. Install the I/O board.
5. Install the touchpad assembly.
6. Install the speakers.
7. Install the heat sink.
8. Install the display assembly.
9. Install the battery.
10. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive from M.2 card slot, whichever applicable.
11. Install the base cover.
12. Follow the procedure in After working inside your computer.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
42
Removing and installing components
To Next Page
Loading...
