Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
2. Slide the solid-state drive into the M.2 card slot on the system board.
3. Replace the screw (M2x3) that secures the solid-state drive to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the 3-cell battery (41 Wh) or the 4-cell battery (54 Wh), whichever applicable.
4. Remove the wireless card.
About this task
NOTE: The antenna cable of Wireless Local Area Network and speaker cable are combined as an assembly.
The following image indicates the location of the speakers and provides a visual representation of the removal procedure.
Removing and installing components
31
To Next Page
Loading...
