Steps
1. Align the ports on the I/O board to the slots on the palm-rest and keyboard assembly.
2. Place the I/O board on the palm-rest and keyboard assembly.
3. Align the screw hole on the I/O board to the screw hole on the palm-rest and keyboard assembly.
4. Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
5. Connect the I/O-board cable to the connector on the I/O board and close the latch.
6. Connect the power-button with fingerprint-reader cable to the connector on the I/O board and close the latch.
NOTE: This step is only applicable to computers shipped with the optional fingerprint reader.
7. Connect the coin-cell battery cable to the I/O board.
8. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
9. Replace the two screws (M2.5x4) that secure the left-display hinge to the I/O board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Power-button
Removing the power-button
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the fan.
4. Remove the display assembly.
Removing and installing components
45
To Next Page
Loading...
